Clutch Pedal Clevis

Moderator: Larry Jowdy

Clutch Pedal Clevis

Postby TSchommer » Sun Apr 02, 2017 11:05 am

I have quite a bit of play in my clutch pedal, probably over 3/4" and I traced most of the issue to the clevis. It seems the holes have ovaled out over the years, and the 1/16" inch of play at the clevis translates into 3/4" at the actual pedal. Replacing is obviously pretty easy, but i'm having trouble finding a replacement. My master cylinder is a Wilwood .625" with 5/16" 24 threads on the rod.

I found this part from CB Performance, but there are no specs on the size or threads.
https://www.cbperformance.com/product-p/6627.htm

I also found this part from Wilwood PN# 330-13192 (Pic Attached),but the length of the opening is quite a bit shorter than the existing one.

I'm just wondering if anyone has any experience with this issue, or either of the two parts I have found. I just want to make sure I order something that will work.

Thanks
Attachments
$_35.JPG
$_35.JPG (7.73 KiB) Viewed 865 times
Screen Shot 2017-04-02 at 1.46.30 PM copy.jpg
Last edited by TSchommer on Fri Apr 21, 2017 8:14 pm, edited 1 time in total.
TSchommer
$$Donating Member$$
$$Donating Member$$
 
Posts: 138
Joined: Sun Jan 20, 2013 6:30 pm

Re: Clutch Pedal Clevis

Postby TSchommer » Sun Apr 09, 2017 12:34 pm

Just in case anyone was wondering, the CNC part I linked to from CB Performance worked just fine. The thread pitch for the master cylinder rod is 5/16 24, and clevis pin opening is 1/4, so it matched up to the hole in my clutch pedal arm perfectly. I could only find anodized ones, so I just used oven cleaner to remove the red coating.

I did find some steel ones that had 5/16" pin openings, so if this one wears out again, I might change it out to a steel one, and just bore out the opening on the clutch arm.
Attachments
6627-2T.jpg
6627-2T.jpg (32.76 KiB) Viewed 733 times
TSchommer
$$Donating Member$$
$$Donating Member$$
 
Posts: 138
Joined: Sun Jan 20, 2013 6:30 pm


Return to Tech General

Who is online

Users browsing this forum: Yahoo [Bot] and 7 guests