Heim Joint Carb Linkage...how to build drawings

A forum where you can load photo's of your car, work in progress, completed projects and just about anything else that you'd like to "show off"

Moderator: Larry Jowdy

Heim Joint Carb Linkage...how to build drawings

Postby JRGilbert » Mon Mar 19, 2018 5:25 am

Feel free to contact me if additional information is needed.

This is how I did it.
You're welcome to the information.
You do it your way...
Last edited by JRGilbert on Wed Mar 21, 2018 12:22 pm, edited 1 time in total.
User avatar
$$Donating Member$$
$$Donating Member$$
Posts: 53
Joined: Tue Oct 25, 2016 7:46 am
Location: Madison, MS

Re: Heim Joint Carb Linkage...how to build drawings

Postby DannyP » Wed Mar 21, 2018 9:53 am

The only thing I'll add is for CB linkage it will be a little cheaper. No need for aluminum plate, you can just cut the ears off the existing carb bases. File, grind, sand flush and flat.

The hexbar has a 8mm or 5/16" hole in the end. So instead of 6mm heims, I bought 5/16" female heims.

I drilled the bar deeper and threaded for 5/16"-18, then loctited in a 3" long bolt, then cut the head off.

Easy peasy, and about 20-25 bucks.

Ended up like this:
https://www.speedsterowners.com/fileSen ... 404046.jpg
2016 Vintage
User avatar
$$Donating Member$$
$$Donating Member$$
Posts: 4259
Joined: Tue Oct 16, 2001 11:00 pm
Location: Wallkill,NY,USA

Return to Show off Photo Gallery

Who is online

Users browsing this forum: No registered users and 1 guest